Čeština
Fóra
Uživatelé
Zcubed
Aktivita
 
Notifications
Clear all
Zcubed
Zcubed
Skupina: Registrovaný
Přidal se: 2017/10/10
Eminent Member
2
Profile Aktivita
The only quirk I've noticed so far is that the printer will ...

In forum General discussion, announcements and releases

 před 6 years
Ordered just the MMU2 separately from the MK3, pretty much r...

In forum General discussion, announcements and releases

 před 6 years
Congrats! Ordered 10/19 with no movement yet but sounds like...

In forum General discussion, announcements and releases

 před 6 years
Goo Off is what worked best for me. It's acetone with some o...

In forum General discussion, announcements and releases

 před 7 years
I wrapped some kapton tape around the top of it. Its kind of...

In forum General discussion, announcements and releases

 před 7 years
I also added heatsinks which just delays the issue for longe...

In forum General discussion, announcements and releases

 před 7 years
You could try my fix for this issue here: I had the exact...

In forum Hardware, firmware and software help

 před 7 years
I also added heatsinks which just delays the issue for longe...

In forum General discussion, announcements and releases

 před 7 years
You could try my fix for this issue here: I had the exact...

In forum How do I print this? (Printing help)

 před 7 years
You could try my fix for this issue here: I had the exact...

In forum Assembly and first prints troubleshooting

 před 7 years
Not sure if anyone else is having this issue with a RPi Zero...

In forum Hardware, firmware and software help

 před 7 years
I think using fasteners into the block to hold the sock in p...

In forum Others (Archive)

 před 7 years
Stránka 2 / 2
Share: