Prusa3D Forum

Notifications

Clear all

Zayar Naung

Skupina: Registrovaný

Přidal se: 2019/01/28

Active Member

	On the bright side, it's a relatively cheap mistake to repai... In forum Hardware, firmware and software help	před 6 years
	Thanks for the link. Yeah! that was my fault. First, I did n... In forum Hardware, firmware and software help	před 6 years
	Yes. I used Acetone each time. I start using after I chat wi... In forum Hardware, firmware and software help	před 6 years
	Thank you for advice brother. I will contact via chat but re... In forum Hardware, firmware and software help	před 6 years
	Smooth PEI Sheet Crack both side. Did happen to you? In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

565 Fóra

63.4 K Témata

445.5 K Příspěvky

18 Online

68.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts Mark all read

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed