Activity
 
Notifications
Clear all
ZARIBO
ZARIBO
Group: Registered
Joined: 2016/10/20
Trusted Member
3
hey many thanks for this information. I will get this item. ...

In forum Prusa i3 kit (Archive)

8 years ago
I have the same issue with the left back screw, and I didn't...

In forum Prusa i3 kit (Archive)

8 years ago
Room temperature is about 23-24 degrees and the printer is j...

In forum Prusa i3 kit (Archive)

8 years ago
Power supply Upgrade for faster heating

In forum Prusa i3 kit (Archive)

8 years ago
I know, but I am not asking that. I am talking about the Pru...

In forum Prusa i3 kit (Archive)

8 years ago
Thank you for the information.

In forum Prusa i3 kit (Archive)

8 years ago
Prusa branded Slicer release date?

In forum Prusa i3 kit (Archive)

8 years ago
MK42 Heatbed slow heating

In forum Prusa i3 kit (Archive)

8 years ago
I am looking forward for the incoming Prusa Slicer

In forum General discussion, announcements and releases

8 years ago
S3D shows 10 hours for the print but the actual print time t...

In forum General discussion, announcements and releases

8 years ago
Many thanks, I will give it a try...

In forum Prusa i3 kit (Archive)

8 years ago
Noctua fan installation is easy but a little bit tricky beca...

In forum Prusa i3 kit (Archive)

8 years ago
Those dampers on the steppers are known as they have a negat...

In forum Prusa i3 kit (Archive)

8 years ago
sorry for late reply because I don't recieve notifications f...

In forum Prusa i3 kit (Archive)

8 years ago
Can't say if it is a start or a stop. As you see in the pict...

In forum Prusa i3 kit (Archive)

8 years ago
Small dents? What is the reason

In forum Prusa i3 kit (Archive)

8 years ago
Is there a way to attach this sensor to the RAMBO board itse...

In forum Improvements (Archive)

8 years ago
Instead of rasperry pi, I have installed octoprint to my old...

In forum Hardware, firmware and software help

8 years ago
Some other experience from istanbul, I have not tried any ot...

In forum Prusa i3 kit (Archive)

8 years ago
Dial button sometimes does not press

In forum Hardware, firmware and software help

8 years ago
Page 2 / 3
Share: