|
They are the stepper motors they can oscillate and make a mu... In forum General discussion, announcements and releases |
5 years ago |
|
The first thing I would do is to double-check the electronic... In forum Assembly and first prints troubleshooting |
5 years ago |
|
@tim-m30 That happened to me, definitely could be an issue w... In forum Hardware, firmware and software help |
5 years ago |
|
Hi, first thing I would do would to check the pinda probe, i... In forum Hardware, firmware and software help |
5 years ago |
|
Hi, you can either delete the folder and then empty the recy... In forum General software discussion |
5 years ago |
|
Yes this used to happen to me a lot. Try to clean it, in cas... In forum Assembly and first prints troubleshooting |
5 years ago |
|
Yess! This is a major problem for me, I switched back to 3.7... In forum Hardware, firmware and software help |
5 years ago |
|
When I first got my printer the lamps plugged into the power... In forum General discussion, announcements and releases |
5 years ago |
|
Have you tried upgrading the firmware to 3.7.2? And if you h... In forum Hardware, firmware and software help |
5 years ago |
|
The silver filament that I got with my mk3 is definitely not... In forum General discussion, announcements and releases |
5 years ago |
|
Yes, I would recommend you upgrade it as soon as it appeared... In forum General discussion, announcements and releases |
5 years ago |
|
I had an issue with the PSU when I woke up from sleep and th... In forum Hardware, firmware and software help |
7 years ago |
