Prusa3D Forum

Notifications

Clear all

yophosis

Group: Registered

Joined: 2019/11/22

Active Member

	Thank you for the replies. I will go to the hardware store w... In forum Hardware, firmware and software help	5 years ago
	Ok, I will focus on one question: How do you get these set s... In forum Hardware, firmware and software help	5 years ago
	I should include more information; the first time I replaced... In forum Hardware, firmware and software help	5 years ago
	Heat Block loose? Heat break set-screws really 1.5mm? In forum Hardware, firmware and software help	5 years ago
	This is really easy to do once you get the hang of it, open ... In forum Assembly and first prints troubleshooting	5 years ago
	The smooth PEI steel sheet grabs the filament much better fo... In forum Assembly and first prints troubleshooting	5 years ago
	Had this problem. Before I click "load filament" I open the... In forum Assembly and first prints troubleshooting	5 years ago
	@whmacintosh I have a theory that the USB sticks are overhea... In forum Hardware, firmware and software help	5 years ago
	Smaller print jobs print just fine with the supplied prusa U... In forum Hardware, firmware and software help	5 years ago
	This just happened to me 10 hours in on a print. I used Slic... In forum Hardware, firmware and software help	5 years ago

Forum Statistics

585 Forums

67.9 K Topics

475.9 K Posts

14 Online

75.5 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed