Avisos
Vaciar todo
yo3ggx
Grupo: Registrado
Registrado: 2016/11/16
Active Member
1
|
Calibrating MK2.5 with the latest firmware En el foro Hardware, firmware and software help |
hace 5 months | |
|
@bobstro Didn't tried to revert to an older firmware. I stil... En el foro Hardware, firmware and software help |
hace 5 years | |
|
@bobstro Hi. Yes, as requested, without the steel sheet. My ... En el foro Hardware, firmware and software help |
hace 5 years | |
|
Z calibration failure after upgrade to 9.1 En el foro Hardware, firmware and software help |
hace 5 years | |
|
Broken bed heating connector En el foro Hardware, firmware and software help |
hace 5 years | |
| It is, as the bed temperature was set to 50 deg in the pictu... | hace 8 years | |
| The rest of the bed is heated as expected, jost the red area... | hace 8 years | |
| My heated bed is deffective | hace 8 years | |
|
Issues will all materials En el foro Others (Archive) |
hace 8 years | |
|
Printing with orange HobbyKing HIPS En el foro Others (Archive) |
hace 9 years |