Notifications
Clear all
yo3ggx
Group: Registered
Joined: 2016/11/16
Active Member
1
|
Calibrating MK2.5 with the latest firmware In forum Hardware, firmware and software help |
4 months ago | |
|
@bobstro Didn't tried to revert to an older firmware. I stil... In forum Hardware, firmware and software help |
5 years ago | |
|
@bobstro Hi. Yes, as requested, without the steel sheet. My ... In forum Hardware, firmware and software help |
5 years ago | |
|
Z calibration failure after upgrade to 9.1 In forum Hardware, firmware and software help |
5 years ago | |
|
Broken bed heating connector In forum Hardware, firmware and software help |
5 years ago | |
| It is, as the bed temperature was set to 50 deg in the pictu... | 7 years ago | |
| The rest of the bed is heated as expected, jost the red area... | 7 years ago | |
| My heated bed is deffective | 8 years ago | |
|
Issues will all materials In forum Others (Archive) |
8 years ago | |
|
Printing with orange HobbyKing HIPS In forum Others (Archive) |
9 years ago |