Notifications
Clear all
YKK2022
Skupina: Registrovaný
Přidal se: 2022/07/09
Active Member
1
|
When printing with Slicer2.5.0, the cross section is not pri... In forum How do I print this? (Printing help) |
před 2 years | |
| I want to make it more beautiful | před 2 years | |
|
thank you for your reply. The filament was successfully load... In forum Assembly and troubleshooting |
před 2 years | |
|
Filament does not load automatically. In forum Assembly and troubleshooting |
před 2 years | |
|
thank you for your answer. It ’s okay because it ’s tightene... In forum Assembly and troubleshooting |
před 2 years | |
|
Thank you for your reply. There are no nuts here. The hole i... In forum Assembly and troubleshooting |
před 2 years | |
|
The screw is loose and the fan cannot be tightened. In forum Assembly and troubleshooting |
před 2 years |