Prusa3D Forum

Notifications

Clear all

Yangorang

Groupe: Enregistré

A(ont) rejoint: 2021/08/01

Active Member

	I found that my Y-carriage was slightly warped and essential... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 3 years
	Is there any official response from Prusa on this? I just m... Dans le forum Hardware, firmware and software help	il y a 3 years
	Is it normal for PLA prints to leave a clear outline on the ... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I was actually just fine-tuning that and have pictures in an... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Right so if I've got an elephants foot and curling edges the... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	First Layer Calibration / Benchy Bottom Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I'm using the 0.2mm quality profile with no raft so my under... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Z-Axis Dimension Calibration? Dans le forum Assembly and first prints troubleshooting	il y a 3 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.7 K Messages

23 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé