Prusa3D Forum

Notifications

Clear all

Yangorang

Group: Registered

Joined: 2021/08/01

Active Member

	I found that my Y-carriage was slightly warped and essential... In forum User mods - OctoPrint, enclosures, nozzles, ...	3 years ago
	Is there any official response from Prusa on this? I just m... In forum Hardware, firmware and software help	3 years ago
	Is it normal for PLA prints to leave a clear outline on the ... In forum Assembly and first prints troubleshooting	3 years ago
	I was actually just fine-tuning that and have pictures in an... In forum Assembly and first prints troubleshooting	3 years ago
	Right so if I've got an elephants foot and curling edges the... In forum Assembly and first prints troubleshooting	3 years ago
	First Layer Calibration / Benchy Bottom In forum Assembly and first prints troubleshooting	3 years ago
	I'm using the 0.2mm quality profile with no raft so my under... In forum Assembly and first prints troubleshooting	3 years ago
	Z-Axis Dimension Calibration? In forum Assembly and first prints troubleshooting	3 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.8 K Posts

21 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed