Notifications
Clear all
wsurf4me
wsurf4me
Skupina: Registrovaný
Přidal se: 2021/11/06
Eminent Member
2
This makes alot of sense to me, here in Florida I haven't ha...

In forum Hardware, firmware and software help

před 6 months
I haven't had this error since upgrading to 5.1.2. I recentl...

In forum Hardware, firmware and software help

před 8 months
I installed RC3, now PrusaLink no longer works. I have wifi ...

In forum General discussion, announcements and releases

před 8 months
I tried fooling the printer by using the single extruder XL ...

In forum How do I print this? (Printing help)

před 10 months
So I've tried copying the method used for the MK4, changed e...

In forum How do I print this? (Printing help)

před 10 months
How to do 4 Colors, 1 Layer, Dual Head XL

In forum How do I print this? (Printing help)

před 10 months
Thanks for this, I've been seeing the issues described for s...

In forum Input Shaper (MK4)

před 11 months
Received a reply from tech support today, "Please install th...

In forum Hardware, firmware and software help

před 1 year
I contacted support via email, explained the issue and provi...

In forum Hardware, firmware and software help

před 1 year
So I've done multiple long prints now without tool change an...

In forum Hardware, firmware and software help

před 1 year
Interesting, I have been doing multihead prints and color ch...

In forum Hardware, firmware and software help

před 1 year
Tried new Samsung USB key, still getting failures. Seems to ...

In forum Hardware, firmware and software help

před 1 year
Agreed, I get a blob from leaking filament then a gap when r...

In forum Hardware, firmware and software help

před 1 year
Unfortunately you are correct, I didn't make it very far bef...

In forum Hardware, firmware and software help

před 1 year
Thanks for that, I was trying everything under the sun. May ...

In forum Hardware, firmware and software help

před 1 year
Did one print successfully with new USB key, tried another a...

In forum Hardware, firmware and software help

před 1 year
Doing a full format on the Prusa USB drive, in the meantime ...

In forum Hardware, firmware and software help

před 1 year
It happened again with gcode from 2.6.1 slicer, just freezes...

In forum Hardware, firmware and software help

před 1 year
USB error mid print

In forum Hardware, firmware and software help

před 1 year
Sorry to jump in but I'm having the same issue after 6 month...

In forum Hardware, firmware and software help

před 3 years
Share: