Notifications
Clear all
wolph42
wolph42
Skupina: Registrovaný
Přidal se: 2022/06/21
Active Member
1
thanks, ill investigate that!

In forum Hardware, firmware and software help

před 3 months
constant filament loading errors (while there are no filamen...

In forum Hardware, firmware and software help

před 3 months
that will work fine as well, thanks!

In forum Hardware, firmware and software help

před 4 months
so, no?! not possible?

In forum Hardware, firmware and software help

před 4 months
How to map colors of items to match spool order?

In forum Hardware, firmware and software help

před 4 months
ok status update: cleaning the bed with soap did indeed help...

In forum Input Shaper (MK4)

před 7 months
the EM is a good tip and makes sense, I'm currently printing...

In forum Input Shaper (MK4)

před 7 months
and all the feedback is very much appreciated! thank you for...

In forum Input Shaper (MK4)

před 7 months
thank you all for the feedback on warping (I do see the 'wat...

In forum Input Shaper (MK4)

před 7 months
I really doubt it. The 'warping' was worse in another corner...

In forum Input Shaper (MK4)

před 7 months
I really doubt it. The 'warping' was worse in another corner...

In forum Input Shaper (MK4)

před 7 months
Weird scars on surface of print

In forum Input Shaper (MK4)

před 7 months
In case someone else comes across this issue: I've figured ...

In forum Hardware, firmware and software help

před 10 months
Thank you all for you helpfull replies. Good point on the el...

In forum Hardware, firmware and software help

před 10 months
I thought it was fairly obvious that the brim was off, this ...

In forum Hardware, firmware and software help

před 11 months
[BUG?] Elephant foot compensation not working on MK4

In forum Hardware, firmware and software help

před 11 months
first/2nd layer issues

In forum Hardware, firmware and software help

před 11 months
difficulty printing pin bed

In forum How do I print this? (Printing help)

před 2 years
Share: