Notifications
Clear all
Walter Senekal
Skupina: Registrovaný
Přidal se: 2021/02/16
Active Member
1
|
I would suggest to go through this setup and make sure your... In forum PrusaSlicer |
před 2 years | |
|
Hi Yes I was able to get it to work properly My main issue w... In forum PrusaSlicer |
před 2 years | |
|
Hi Joan Thanks, I will definitely give this a try. I see the... In forum PrusaSlicer |
před 4 years | |
|
Prusa Slicer 2.3.0 on Ender 3 V2, facing over extruding issu... In forum PrusaSlicer |
před 4 years |