Notifiche
Cancella tutti
Walter Senekal
Gruppo: Registrato
Registrato: 2021/02/16
Active Member
1
|
I would suggest to go through this setup and make sure your... Nel forum PrusaSlicer |
3 years fa | |
|
Hi Yes I was able to get it to work properly My main issue w... Nel forum PrusaSlicer |
3 years fa | |
|
Hi Joan Thanks, I will definitely give this a try. I see the... Nel forum PrusaSlicer |
5 years fa | |
|
Prusa Slicer 2.3.0 on Ender 3 V2, facing over extruding issu... Nel forum PrusaSlicer |
5 years fa |