Notifications
Clear all
Wahapainan
Skupina: Registrovaný
Přidal se: 2024/06/11
Active Member
1
| Yes, some sort of clip, or have the set screw capture the ba... | před 3 months | |
| Just ordered some spares to keep on hand, good suggestion. B... | před 3 months | |
| FYI, thermistor failed, found set screw was way too tight. | před 3 months | |
|
In Prusaslicer click the gear on the right of your printer o... In forum User mods |
před 4 months | |
|
After going through the calibrations on my MK3S+ and continu... In forum Hardware, firmware and software help |
před 2 years |