Prusa3D Forum

Notifications

Clear all

vlct

Skupina: Registrovaný

Přidal se: 2019/04/17

Active Member

	Hi, it was the extruder motor cable that had some sort of a ... In forum Hardware, firmware and software help	před 3 years
	Just for documentation.. this is how a broken cable might lo... In forum Hardware, firmware and software help	před 5 years
	@robert-rmm200 Thanks, this was really difficult to find, fe... In forum Hardware, firmware and software help	před 5 years
	I think i finally found it, broken cable where the cables en... In forum Hardware, firmware and software help	před 5 years
	Extruder not working when on right side of the printer In forum Hardware, firmware and software help	před 5 years
	Hi, Have you found a solution by any chance? I have the ex... In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.3 K Příspěvky

20 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed