Prusa3D Forum

Notifications

Clear all

Visitor247

Groupe: Enregistré

A(ont) rejoint: 2019/05/04

Active Member

	Small update: I changed the additional gcode from == to >... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Back again, and a lot happened. The new nozzle made a differ... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	I forgot to mention: I did do two cold pulls but there was n... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Well…, I was looking for the second nozzle I mentioned but w... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks for the fast answers. I finally found some time to tr... Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Stringing after clogged nozzle Dans le forum Assembly and first prints troubleshooting	il y a 6 years
	Thanks David, I will do exactly that, as soon as my printer ... Dans le forum Hardware, firmware and software help	il y a 6 years
	Import Slic3r gcode into Prusa Control problem Dans le forum Hardware, firmware and software help	il y a 6 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.4 K Messages

22 En-ligne

69.4 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé