Notifications
Clear all
Visayan7
Skupina: Registrovaný
Přidal se: 2020/12/06
Active Member
1
|
@neophyl Ah, I think that might be the reason. I always igno... In forum PrusaSlicer |
před 4 years | |
|
Z hop/lift z disables after a certain height on different pr... In forum PrusaSlicer |
před 4 years | |
| @rolf-2 Glad you sorted out. Still having issues with mine. | před 4 years | |
| @joantabb Like I said nothing appears to be stiff. The X and... | před 4 years | |
| @joantabb It had the most recent firmware and I tried an old... | před 4 years | |
| @joantabb Bearings have been lubricated but with WD40 white ... | před 4 years | |
| @rolf-2 Your problem I believe is a little different caused ... | před 4 years | |
| @joantabb Ok problems still arise even without the sensor co... | před 4 years | |
| @joantabb I have not tried that. So I can disconnect the IR ... | před 4 years | |
| MK3S keeps prompting unload filament | před 4 years |