Prusa3D Forum

Notifiche

Cancella tutti

Verris

Gruppo: Registrato

Registrato: 2015/06/24

Active Member

	Original 3mm -> 1.75mm -> MK2 Upgrade Nel forum Others (Archive)	9 years fa
	I have been running it this way daily for the last few month... Nel forum Improvements (Archive)	10 years fa
	I think my customs fee was something around $106 to Ottawa C... Nel forum Prusa i3 kit (Archive)	10 years fa
	I just used two pieces off of these Nel forum Improvements (Archive)	10 years fa
	The 5v out is on one of these pins in the purple box. I don'... Nel forum Improvements (Archive)	10 years fa
	Nope, I replaced the felt feet with rubber feet to get it to... Nel forum Improvements (Archive)	10 years fa
	Thanks Josef, I've sent an email. Nel forum Prusa i3 kit (Archive)	10 years fa
	Looks right, now just trying to source one or two 370mm rods... Nel forum Prusa i3 kit (Archive)	10 years fa
	Part List Nel forum Prusa i3 kit (Archive)	10 years fa
	Now with 1.75mm extruder and greatly improved (shortened) wi... Nel forum Improvements (Archive)	10 years fa
	More Prints Nel forum Awesome prints (Hall Of Fame)	10 years fa
	Raspberry Pi and Camera Setup Nel forum Improvements (Archive)	10 years fa

Statistiche Forum

595 Forum

68.8 K Discussioni

481.6 K Post

15 Online

77.5 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso