|
Thank you for this. Here's the difference it can make for a ... In forum Others (Archive) |
7 years ago |
|
Question for those that rotated the rods due to scratches: d... In forum Hardware, firmware and software help |
7 years ago |
|
Cannot enable filament sensor In forum Others (Archive) |
7 years ago |
|
Customer Support Representative In forum General discussion, announcements and releases |
7 years ago |
|
Yes, it has to be black to keep light out (Josef mentioned i... In forum Others (Archive) |
7 years ago |
|
Problem solved with a new filament sensor, quickly shipped a... In forum Others (Archive) |
7 years ago |
|
No, there are several checksum errors. The print however app... In forum Others (Archive) |
7 years ago |
|
There you go, attached. In forum Others (Archive) |
7 years ago |
|
Re: Prints stalling randomly In forum Others (Archive) |
7 years ago |
|
Just successfully printed a 5 hour print with USB, using lat... In forum Others (Archive) |
7 years ago |
|
Agreed, that's how it is on the Ultimaker as well:
- load f... In forum Others (Archive) |
7 years ago |
|
Same here, but in my case it never worked (always shown as N... In forum Others (Archive) |
7 years ago |
|
You need to use the brim support option, at least 5 mm I'd s... In forum Prusa i3 kit (Archive) |
7 years ago |
|
It would explain why my belt kept showing 280 despite it bei... In forum How do I print this? (Printing help) |
7 years ago |
|
The idea seems to be the filament sensor detects when you at... In forum Others (Archive) |
7 years ago |
|
Mostly, from here:
When it's final/tested, from here: In forum Others (Archive) |
7 years ago |
|
Yes, same with new 138 firmware - the self test fails with a... In forum Others (Archive) |
7 years ago |
|
Same problem here with the stock PLA profile, Prusa Silver P... In forum Others (Archive) |
7 years ago |
|
Initially I thought the same - how to update the PSU when th... In forum Hardware, firmware and software help |
7 years ago |
|
Cannot enable filament sensor In forum Others (Archive) |
7 years ago |