|
when i updated my printer with new FW filament sensor turned... In forum Others (Archive) |
7 years ago |
|
Thanks! Any tips on correcting bed level problems other than... In forum Others (Archive) |
7 years ago |
|
1 - not a major problem, happened to me as well. Just cover ... In forum Others (Archive) |
7 years ago |
|
From the PDF manual:
PETG sticks very well to PEI, which is... In forum Others (Archive) |
7 years ago |
|
There are a lot of threads opened with the same question, tr... In forum Others (Archive) |
7 years ago |
|
See the footnote in your order history page, here: In forum Others (Archive) |
7 years ago |
|
Polls don't work either 😐 In forum Improvements (Archive) |
7 years ago |
|
Not to mention they also have cheap eSun and HobbyKing filam... In forum Others (Archive) |
7 years ago |
|
What better reason to get a roll of polycarbonate filament ?... In forum Others (Archive) |
7 years ago |
|
HobbyKing !
Nylon nuts and bolts
Countersunk
Button head In forum Others (Archive) |
7 years ago |
|
Cancel or not?
Generally, asking other people to make up y... In forum Others (Archive) |
7 years ago |
|
M3 hardware as in what, screws and nuts ? In forum Others (Archive) |
7 years ago |
|
Noticed a hint of what apperas to be rust on my MK3's gears ... In forum Others (Archive) |
7 years ago |
|
Nope, there's no trick. There's a slit in the middle that c... In forum Others (Archive) |
7 years ago |
|
This too has been addressed, @JLTX modified the back cover t... In forum Others (Archive) |
7 years ago |
|
... in what will be probably the week's most shared article ... In forum Others (Archive) |
7 years ago |
|
Yes, it's been discussed in other threads and it's happening... In forum Others (Archive) |
7 years ago |
|
Same here (0.2 mm, ABS, Octopi 1.3.6, firmware b143e, USB), ... In forum General discussion, announcements and releases |
7 years ago |
|
320 mm. In forum Others (Archive) |
7 years ago |
|
From reading around, it seems the steel nozzle is slower to ... In forum Others (Archive) |
7 years ago |