|
In the end I went with hand editing the gcode. Which works, ... In forum How do I print this? (Printing help) |
9 months ago |
|
The paths shown is with Avoid Crossing Perimeters on In forum How do I print this? (Printing help) |
9 months ago |
|
Here is an extended inner race bearing. Though mine only ext... In forum How do I print this? (Printing help) |
9 months ago |
|
The blue inner circumference is the pause point, where the b... In forum How do I print this? (Printing help) |
9 months ago |
|
Any way to print with a "no-go" zone? In forum How do I print this? (Printing help) |
9 months ago |
|
A little late for that, the card doesn't even mount anymore.... In forum Hardware, firmware and software help |
1 year ago |
|
Then it is FAT32, as I haven't done anything with it other t... In forum Hardware, firmware and software help |
1 year ago |
|
It's not the only file on the drive. It's the SD that came w... In forum Hardware, firmware and software help |
1 year ago |
|
The filename is generated by prusaslicer, it contains nothin... In forum Hardware, firmware and software help |
1 year ago |
|
SD Card reader does not see newest gcode file In forum Hardware, firmware and software help |
1 year ago |
|
5 year necro, but if anyone finds this thread in search of a... In forum Assembly and first prints troubleshooting |
1 year ago |
|
Heated nozzle requirement to manually move extruder stepper? In forum Hardware, firmware and software help |
1 year ago |