Prusa3D Forum

Notifications

Clear all

ugo.m

Groupe: Enregistré

A(ont) rejoint: 2015/12/04

Active Member

	Lastest compatible FW for Prusa i3 (MK1) Dans le forum Software (Archive)	il y a 7 years
	Thanks again Peter! The more I learn about 3d printers and ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Peter, Great! thanks for checking on those endstops Pete... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	So the Z endstop is bad. I was offered a replacement but pay... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	wires are not damaged... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	The pictures were taken after I started to take the harness ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Z end stop and wiring pictured Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	that is a great idea! 🙂 BTW here is a picture of the botto... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I took more pictures and will send them asap. Checked and ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Peter, I chatted with Grayson online and referred him to... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Thank you Peter! I only have PLA filament and have been usi... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Thanks Peter! I was able to test the Z stop and Z min pins ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	What is the best way to test the current Z stop to make sure... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	HI Peter! Thank you for your reply. I have included anothe... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	wouldn't this be a better part to use for connecting the Z m... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	I have needed to add the copper spacers under the smooth Z r... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Z motor and M5 threaded Z rod connection Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

19 En-ligne

68.1 K Membres

Le dernier des messages: Upgrade path from MK3.5 to MK3.9s ? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé