Prusa3D Forum

Notifications

Clear all

twobert

Skupina: Registrovaný

Přidal se: 2022/02/03

New Member

	I had to hold on before completing the build until the repla... In forum Assembly and first prints troubleshooting	před 3 years
	Thanks, it was solved. Turned out either the bondtech gear o... In forum Assembly and first prints troubleshooting	před 3 years
	Can't get bond tech gear to push down onto shaft of extruder... In forum Assembly and first prints troubleshooting	před 3 years

Fórum Statistiky

559 Fóra

62.9 K Témata

442.9 K Příspěvky

18 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed