Trimetric – Aktivita – Prusa3D Forum

Notifications

Clear all

Trimetric

Skupina: Registrovaný

Přidal se: 2021/02/20

Trusted Member

	I’ve never really used it for PLA other than a few samples a... In forum Assembly and first prints troubleshooting	před 4 years
	@technical-ted Yeah, I use the smooth sheet for all PLA and ... In forum Assembly and first prints troubleshooting	před 4 years
	@diem Not really. The humidity was about 37% at the time. I’... In forum Assembly and first prints troubleshooting	před 4 years
	@diem Yeah, that would make sense. But I had literally just ... In forum Assembly and first prints troubleshooting	před 4 years
	@technical-ted I had the same exact problem with my Benchy o... In forum Assembly and first prints troubleshooting	před 4 years
	If I want to adjust my SPINDA height, can I just move the no... In forum Assembly and first prints troubleshooting	před 4 years
	@loak Ah, ok. So maybe when I see people with much lower val... In forum Assembly and first prints troubleshooting	před 4 years
	Higher live Z values In forum Assembly and first prints troubleshooting	před 4 years
	Since I already had the markings on the bearings, I only had... In forum Assembly and first prints troubleshooting	před 4 years
	@clarmrrsn Ah ok. I see that now. Since that part wasn’t in ... In forum Assembly and first prints troubleshooting	před 4 years
	Marked bearings on X-axis during assembly but didn't do anyt... In forum Assembly and first prints troubleshooting	před 4 years

Stránka 3 / 3 Předchozí

Fórum Statistiky

565 Fóra

63.7 K Témata

447 K Příspěvky

19 Online

69.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed