|
@karl-herbert Since this happened and after cleaning up ever... Nel forum General discussion, announcements and releases |
4 years fa |
|
@karl-herbert Well almost, thinking it was a bad connection ... Nel forum General discussion, announcements and releases |
4 years fa |
|
@karl-herbert Oh agree, its got to prove itself again.
&n... Nel forum General discussion, announcements and releases |
4 years fa |
|
@karl-herbert Oh sorry it was 105k ohms. It printed sample j... Nel forum General discussion, announcements and releases |
4 years fa |
|
@karl-herbert Sorry, no hardware changes after or before sof... Nel forum General discussion, announcements and releases |
4 years fa |
|
@karl-herbert I'm thinking more hardware as well. I will che... Nel forum General discussion, announcements and releases |
4 years fa |
|
@charles-h13 I thought to as well. It might have been a fluk... Nel forum General discussion, announcements and releases |
4 years fa |
|
Thermal Runaway with OctoPrint Nel forum General discussion, announcements and releases |
4 years fa |
|
If I'm right about the K factor, it's a kinetic energy of th... Nel forum Hardware, firmware and software help |
5 years fa |
|
I looked closer at the sliced preview and can see it more no... Nel forum Hardware, firmware and software help |
5 years fa |
|
Thanks, I will be checking some of these suggested settings... Nel forum Hardware, firmware and software help |
5 years fa |
|
Print defect on corners Nel forum Hardware, firmware and software help |
5 years fa |
|
Request Feature: Support Needed Warning Nel forum General discussion, announcements and releases |
6 years fa |
|
Still more odd issues with 3.7.0 firmware Nel forum Hardware, firmware and software help |
6 years fa |
|
Still having issues with 3.7 firmware. Going to unload all... Nel forum Hardware, firmware and software help |
6 years fa |
|
Odd issues after FW 3.6 upgrade Nel forum Hardware, firmware and software help |
6 years fa |
