Prusa3D Forum

Notifications

Clear all

travis

Skupina: Registrovaný

Přidal se: 2021/03/01

New Member

	@clarmrrsn Good question - it was not lifted off of the surf... In forum Assembly and first prints troubleshooting	před 4 years
	@dan-rogers Yes - I always print those with skepticism. In... In forum Assembly and first prints troubleshooting	před 4 years
	Print fails in exact same spot, not first layer In forum Assembly and first prints troubleshooting	před 4 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.4 K Příspěvky

19 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed