|
The USB port is on the upper right side of the screen housin... En el foro Hardware, firmware and software help |
hace 2 weeks |
|
You are confusing the 6.5,2 for the Core One L with the XL ... En el foro Hardware, firmware and software help |
hace 3 months |
|
I don't use Nano Polymer on PEI sheets, in fact I don't use ... En el foro How do I print this? (Printing help) |
hace 3 months |
|
I like my satin sheets. I apply a little Vision Miner Nano P... En el foro How do I print this? (Printing help) |
hace 3 months |
|
SunLu makes a filament connector that works well. Its $45 on... En el foro Hardware, firmware and software help |
hace 3 months |
|
Did you previously send the file to your C1 using Prusa Conn... En el foro General discussion, announcements and releases |
hace 4 months |
|
I have used Vision Miner Nano Polymer Adhesive (available at... En el foro How do I print this? (Printing help) |
hace 4 months |
|
Check out the Creality 3D Printer Heater, PTC Chamber Heater... En el foro General discussion, announcements and releases |
hace 5 months |
|
I have used the Belt Tuning Wizard and it worked very well f... En el foro General discussion, announcements and releases |
hace 5 months |
|
I have had the same problem with my Core One camera after it... En el foro General discussion, announcements and releases |
hace 6 months |
|
While I really liked the improvements in 6.4.0 alpha, I have... En el foro General discussion, announcements and releases |
hace 8 months |
