|
Meine Beobachtung hierzu ist folgende: Solange ein PLA-Filam... In forum General discussion, announcements and releases |
5 years ago |
|
... it doesn't matter which model/part is sliced. The offset... In forum Hardware, firmware and software help |
6 years ago |
|
Z-offset in SLIC3R-PREVIEW In forum Hardware, firmware and software help |
6 years ago |
|
Z offset in preview In forum PrusaSlicer |
6 years ago |
|
Are there (there are) several sub-versions of the 1.05 firmw... In forum General discussion, announcements and releases |
7 years ago |
|
Hallo Thomas,
dann sieht das aber nach einem Problem des Ste... In forum Others (Archive) |
9 years ago |
|
Hallo Thomas,
wenn ich das richtig verstehe, hast Du moment... In forum Others (Archive) |
9 years ago |
|
Hi Michael,
use the PRUSA FirmwareUpdater which is installe... In forum Others (Archive) |
9 years ago |
|
Have a look at the updated manual:
STEP 30 ... In forum Others (Archive) |
9 years ago |
|
Hi Tom,
Sorry. I didn't check the link. It grants view only... In forum Others (Archive) |
9 years ago |
|
This could be your problem: In forum Software (Archive) |
9 years ago |
|
Z-Frame of PRUSA i3 MK2 based on alu-frame.dxf: In forum Others (Archive) |
9 years ago |
|
You can swap the both cables I and II. If the same LCD displ... In forum Others (Archive) |
9 years ago |
|
@prusayo
If you installed 1.7.4 drivers the startcode will ... In forum Others (Archive) |
9 years ago |
|
Firmware (3.06/3.07) Misbehavior after Unload-Load Filament In forum Others (Archive) |
10 years ago |
|
Extra Spare PEI Sheet in the MK2 kit In forum Others (Archive) |
10 years ago |
|
Updated without problem.
Three hints for improvement:
Cali... In forum Others (Archive) |
10 years ago |
|
Hi Vojtech,
no, I didn't check with other cards. But it seem... In forum Others (Archive) |
10 years ago |
|
SD card not recognized (FW 3.0.6-RC2) In forum Others (Archive) |
10 years ago |
|
Notes:
The new calibration process takes about 10 minutes.
... In forum Others (Archive) |
10 years ago |
