Activité
 
Notifications
Clear all
tonitom
tonitom
Groupe: Enregistré
A(ont) rejoint: 2020/12/15
Active Member
1
So the self-locking nuts are still the best solution? I used...

Dans le forum User mods, enclosures, nozzles, ...

il y a 6 months
Sorry, through some microcontoller projects I built, I devel...

Dans le forum General discussion & User Experience & Ideas

il y a 2 years
MQTT would be awesome

Dans le forum General discussion & User Experience & Ideas

il y a 2 years
Hi, I have/had the same problem, after about 2-3h printing t...

Dans le forum Hardware, firmware and software help

il y a 3 years
Ich hatte vor ein paar Tagen das gleiche Problem und bin übe...

Dans le forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

il y a 3 years
Ok, thx. Maybe I expect too much. With 255°C and an exorbita...

Dans le forum General discussion, announcements and releases

il y a 3 years
Hi, sorry, I have to come back to the old topic, but maybe y...

Dans le forum General discussion, announcements and releases

il y a 3 years
I destroyed my PEI sheet with my first ASA print. ASA on sat...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Acetone may be used for PEI sheet metal. And in future print...

Dans le forum How do I print this? (Printing help)

il y a 3 years
@diem Thanks for the information, I will take that into cons...

Dans le forum How do I print this? (Printing help)

il y a 4 years
Ok, with the option detect thin walls you get a smooth surfa...

Dans le forum How do I print this? (Printing help)

il y a 4 years
2mm walls with the 0.6mm nozzle do not come out well. Is the...

Dans le forum How do I print this? (Printing help)

il y a 4 years
ohhh, the new satin sheet is in stock. Maybe this is the sol...

Dans le forum How do I print this? (Printing help)

il y a 4 years
@karl-herbert Ok, thanks, I think I will order a cheap uncoa...

Dans le forum How do I print this? (Printing help)

il y a 4 years
Hi, I destroyed my smooth PEI layer yesterday because of ASA...

Dans le forum How do I print this? (Printing help)

il y a 4 years
Hi, I am also still in the discovery phase and no experience...

Dans le forum General discussion, announcements and releases

il y a 4 years
Partager :