Notifications
Clear all
tonitom
tonitom
Group: Registered
Joined: 2020/12/15
Active Member
1
So the self-locking nuts are still the best solution? I used...

In forum User mods, enclosures, nozzles, ...

7 months ago
Sorry, through some microcontoller projects I built, I devel...

In forum General discussion & User Experience & Ideas

2 years ago
MQTT would be awesome

In forum General discussion & User Experience & Ideas

2 years ago
Hi, I have/had the same problem, after about 2-3h printing t...

In forum Hardware, firmware and software help

3 years ago
Ich hatte vor ein paar Tagen das gleiche Problem und bin übe...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

3 years ago
Ok, thx. Maybe I expect too much. With 255°C and an exorbita...

In forum General discussion, announcements and releases

3 years ago
Hi, sorry, I have to come back to the old topic, but maybe y...

In forum General discussion, announcements and releases

3 years ago
I destroyed my PEI sheet with my first ASA print. ASA on sat...

In forum How do I print this? (Printing help)

3 years ago
Acetone may be used for PEI sheet metal. And in future print...

In forum How do I print this? (Printing help)

3 years ago
@diem Thanks for the information, I will take that into cons...

In forum How do I print this? (Printing help)

4 years ago
Ok, with the option detect thin walls you get a smooth surfa...

In forum How do I print this? (Printing help)

4 years ago
2mm walls with the 0.6mm nozzle do not come out well. Is the...

In forum How do I print this? (Printing help)

4 years ago
ohhh, the new satin sheet is in stock. Maybe this is the sol...

In forum How do I print this? (Printing help)

4 years ago
@karl-herbert Ok, thanks, I think I will order a cheap uncoa...

In forum How do I print this? (Printing help)

4 years ago
Hi, I destroyed my smooth PEI layer yesterday because of ASA...

In forum How do I print this? (Printing help)

4 years ago
Hi, I am also still in the discovery phase and no experience...

In forum General discussion, announcements and releases

4 years ago
Share: