Prusa3D Forum

Notifications

Clear all

tonio.b

Groupe: Enregistré

A(ont) rejoint: 2017/08/03

Active Member

	Thanks Waldemar... But the purpose of this is for stopping t... Dans le forum Improvements (Archive)	il y a 7 years
	Thanks Waldemar... But the purpose of this is for stopping t... Dans le forum Improvements (Archive)	il y a 7 years
	FILAMENT SENSOR ON MINI RAMBO Dans le forum Improvements (Archive)	il y a 7 years
	RE-POSITIONING OF 4 EXTRUDER MOTORS Dans le forum Improvements (Archive)	il y a 7 years
	I looked up what gert1 wrote and followed all. I managed to ... Dans le forum Improvements (Archive)	il y a 7 years
	Basically, I want to activate the Z-minus endstop to fit an ... Dans le forum Improvements (Archive)	il y a 7 years
	Hi David, many thanks for your reply. I am nt offended in a... Dans le forum Improvements (Archive)	il y a 7 years
	FIRMWARE RE-WRITING Dans le forum Improvements (Archive)	il y a 7 years
	Unpredicted nozzle damage to bed Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Hi Joan, I think I iwll not do as I intended. Your reply ha... Dans le forum Improvements (Archive)	il y a 7 years
	You are right Joan, I have to fit switches to close the cont... Dans le forum Improvements (Archive)	il y a 7 years
	I know that the cables power a coil in pairs, ie the four ca... Dans le forum Improvements (Archive)	il y a 7 years
	OVERTRAVEL Dans le forum Improvements (Archive)	il y a 7 years
	HI, THERE IS NOTHING WRONG WITH THE PRINTER you can keep in ... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Bad finish below support material Dans le forum Print tips (Archive)	il y a 7 years
	I am going mad with this.... The machine went well with half... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	Thanks for that, I have already took action to check most of... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	PROBLEMS WITH FILAMENT Dans le forum Prusa i3 kit (Archive)	il y a 7 years

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

19 En-ligne

68.1 K Membres

Le dernier des messages: Please make the $299 MK4S -> Core One voucher available to all who bought an MK4S or MK4 -> MK4S Conversion kit Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé