Notifications
Clear all
Tomáš Ptáčník
Group: Registered
Joined: 2024/01/04
Active Member
1
|
I did that. Thank you. It seemed to have helped, I had about... In forum Hardware, firmware and software help |
10 months ago | |
|
Ongoing under-extrusion after troubleshooting In forum Hardware, firmware and software help |
10 months ago | |
| Same 3mf, same filament - broken print | 11 months ago | |
|
Thank you! Such a banal thing, but your post saved me a lot ... In forum Hardware, firmware and software help |
1 year ago | |
| I had done is using a credit card. The -2.0 height is alread... | 2 years ago | |
| Thank you! I adjusted the nozzle even lower, it rests at 2.0... | 2 years ago | |
| Bottom layers at edges are messed up | 2 years ago |