|
New update.. turns out our Extruder motor was going bad. Re... In forum Hardware, firmware and software help |
4 years temu |
|
Update: Ok, so we even went out and purchased a fully assemb... In forum Hardware, firmware and software help |
4 years temu |
|
Thanks! We'll run it again and when it jams we'll open up th... In forum Hardware, firmware and software help |
4 years temu |
|
The Heatbreak is the last thing we have tried. We've listed... In forum Hardware, firmware and software help |
4 years temu |
|
Hi there, Yes there is a good helping of thermal paste on t... In forum Hardware, firmware and software help |
4 years temu |
|
Thanks! As a note, we did switch out the heat break with a n... In forum Hardware, firmware and software help |
4 years temu |
|
We have also now replaced the heat break and we are still ge... In forum Hardware, firmware and software help |
4 years temu |
|
Here is an example of the rough print that we are seeing whe... In forum Hardware, firmware and software help |
4 years temu |
|
We had that issue as well.. it was the fan wires that weren'... In forum Hardware, firmware and software help |
4 years temu |
|
Print Failing Mid-Print In forum Hardware, firmware and software help |
4 years temu |
