Prusa3D Forum

Notifications

Clear all

Tim

Skupina: Registrovaný

Přidal se: 2018/12/22

Active Member

	After you suggested a bad thermistor, I pulled the cable out... In forum Hardware, firmware and software help	před 6 years
	Vintagepc, Thank you for the quick reply. I dont have an e... In forum Hardware, firmware and software help	před 6 years
	Display shows @ symbols then heat turns off during initial c... In forum Hardware, firmware and software help	před 6 years
	I've been printing non-stop the last few days and there hasn... In forum Hardware, firmware and software help	před 6 years
	It's not the spiral, plastic, cable wrap. I just received th... In forum Hardware, firmware and software help	před 6 years
	Heatbed Thermistor came loose In forum Hardware, firmware and software help	před 6 years
	Hey Chris, I also was getting "Access is denied" when tryin... In forum General discussion, announcements and releases	před 6 years

Fórum Statistiky

565 Fóra

63.8 K Témata

447.3 K Příspěvky

22 Online

69.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed