Prusa3D Forum

Notifications

Clear all

Tim

Group: Registered

Joined: 2018/12/22

Active Member

	After you suggested a bad thermistor, I pulled the cable out... In forum Hardware, firmware and software help	6 years ago
	Vintagepc, Thank you for the quick reply. I dont have an e... In forum Hardware, firmware and software help	6 years ago
	Display shows @ symbols then heat turns off during initial c... In forum Hardware, firmware and software help	6 years ago
	I've been printing non-stop the last few days and there hasn... In forum Hardware, firmware and software help	6 years ago
	It's not the spiral, plastic, cable wrap. I just received th... In forum Hardware, firmware and software help	6 years ago
	Heatbed Thermistor came loose In forum Hardware, firmware and software help	6 years ago
	Hey Chris, I also was getting "Access is denied" when tryin... In forum General discussion, announcements and releases	6 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.8 K Posts

23 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed