Prusa3D Forum

Notifications

Clear all

thomas-4

Grupa: Zarejestrowany

Dołączył: 2019/10/28

Active Member

	@arepaj Check of all screws are fitting well, I think I had ... In forum Assembly and first prints troubleshooting	5 years temu
	Check step 37 if nothing disconnected or came loose. Check L... In forum Assembly and first prints troubleshooting	5 years temu
	@b3-marek thanks for help! I try to connect printer to PC di... In forum Assembly and first prints troubleshooting	5 years temu
	Printer do not turn on any more In forum Assembly and first prints troubleshooting	5 years temu
	Hi, I did a full reset again, and now it's working again, st... In forum Assembly and first prints troubleshooting	5 years temu
	@tim-m30 Ah okay sry now I know what you mean. I think I mis... In forum Assembly and first prints troubleshooting	5 years temu
	Hi, yes I could finish it, not sure what you mean with Live-... In forum Assembly and first prints troubleshooting	5 years temu
	Hey, I'm using the PLA which comes with the printer. I was n... In forum Assembly and first prints troubleshooting	5 years temu
	Hi, thanks for that, but it did not help. I have still the s... In forum Assembly and first prints troubleshooting	5 years temu
	Filament do not flow during print but does good if change fi... In forum Assembly and first prints troubleshooting	5 years temu

Statystyki Forum

565 Fora

63.8 K Tematy

447.4 K Posty

20 Online

69.4 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte