Notifications
Clear all
Thingy
Groupe: Enregistré
A(ont) rejoint: 2024/10/12
Active Member
1
|
Actually I have not, I didn't consider the possibility that ... Dans le forum PrusaSlicer |
il y a 5 months | |
|
Layer count of solid infill less than expected on top of bri... Dans le forum PrusaSlicer |
il y a 5 months | |
|
That's seriously too bad, but in all unseriousness, a slicer... Dans le forum PrusaSlicer |
il y a 5 months | |
|
Still not an answer, just workarounds. And adding another pr... Dans le forum PrusaSlicer |
il y a 1 year | |
|
That is so true, some prints though, like spheres, that have... Dans le forum PrusaSlicer |
il y a 1 year | |
|
That is not a solution, that is a workaround. And it would l... Dans le forum PrusaSlicer |
il y a 1 year | |
|
What setting controls this behavior Dans le forum PrusaSlicer |
il y a 1 year | |
|
Minimum layer height for internal bridging Dans le forum PrusaSlicer |
il y a 1 year |