Notifications
Clear all
Thingy
Group: Registered
Joined: 2024/10/12
Active Member
1
|
Actually I have not, I didn't consider the possibility that ... In forum PrusaSlicer |
3 months ago | |
|
Layer count of solid infill less than expected on top of bri... In forum PrusaSlicer |
3 months ago | |
|
That's seriously too bad, but in all unseriousness, a slicer... In forum PrusaSlicer |
3 months ago | |
|
Still not an answer, just workarounds. And adding another pr... In forum PrusaSlicer |
11 months ago | |
|
That is so true, some prints though, like spheres, that have... In forum PrusaSlicer |
11 months ago | |
|
That is not a solution, that is a workaround. And it would l... In forum PrusaSlicer |
11 months ago | |
|
What setting controls this behavior In forum PrusaSlicer |
11 months ago | |
|
Minimum layer height for internal bridging In forum PrusaSlicer |
11 months ago |