theologos.m – Aktivita – Prusa3D Forum

Notifications

Clear all

theologos.m

Skupina: Registrovaný

Přidal se: 2016/12/02

Eminent Member

	I can only answer a few questions of the top of my head. Re... In forum Prusa i3 kit (Archive)	před 7 years
	Ok - got it. Extruder problem. The brass pulley of extruder ... In forum Prusa i3 kit (Archive)	před 7 years
	Failed prints - with patterns In forum Prusa i3 kit (Archive)	před 7 years
	What is lighter fluid ? Thomas Perhaps this one? In forum Print tips (Archive)	před 7 years
	Had the same problem (different causes) - see here . Basic... In forum Others (Archive)	před 7 years
	Yes, I solved it... by disassembling the entire thing. The l... In forum Others (Archive)	před 7 years
	Thanks. Did it but nothing. If I make the idler tension bigg... In forum Others (Archive)	před 7 years
	🙂 🙂 🙂 ...thanks all for the replies!! In forum Print tips (Archive)	před 7 years
	Nothing is extruded In forum Others (Archive)	před 7 years
	Oh! Thanks a lot. 🙂 In forum Print tips (Archive)	před 7 years
	How to test if the PEI needs changing? In forum Print tips (Archive)	před 7 years
	How to extrude/print "into thin air"? In forum Print tips (Archive)	před 7 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

559 Fóra

62.9 K Témata

443 K Příspěvky

19 Online

67.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed