Prusa3D Forum

Notifications

Clear all

TheOlderBear

Groupe: PreRegistered

A(ont) rejoint: 2025/06/26

Titre: Membre

	So I did check the pulleys and I cannot tight them more. I a... Dans le forum Assembly and first prints troubleshooting	il y a 5 months
	I will check it Chris Hill. This is how my print looks. Dans le forum Assembly and first prints troubleshooting	il y a 5 months
	Hi, I have the exact same behaviour. Spent some time in chat... Dans le forum Assembly and first prints troubleshooting	il y a 5 months
	I read a little bit around and I think my z is to low now. Dans le forum How do I print this? (Printing help)	il y a 5 years
	Hi, printed a lot of different stuff without issue but got a... Dans le forum How do I print this? (Printing help)	il y a 5 years
	So, I think my issue are gone 😀 . I just lowered a little bi... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@Neophyl thanks for your offer, but is a proprietary model a... Dans le forum How do I print this? (Printing help)	il y a 5 years
	That is quite impressive, thanks, I will try again, maybe my... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Maybe some info, it is pla on smooth sheet. Dans le forum How do I print this? (Printing help)	il y a 5 years
	Tall pieces adesion Dans le forum How do I print this? (Printing help)	il y a 5 years

Statistiques du forum

595 Forums

68.9 K Sujets

482.1 K Messages

14 En-ligne

77.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé