Notifications
Clear all
thedavinator37
Skupina: Registrovaný
Přidal se: 2018/12/27
Eminent Member
2
|
I got it figured out. The filament wouldn't push into the PT... In forum Hardware, firmware and software help |
před 6 years | |
|
I'm using PETG and I'm running it at 260. I think it might b... In forum Hardware, firmware and software help |
před 6 years | |
|
This ended up working, thanks a bunch! My U-bolts were too t... In forum Hardware, firmware and software help |
před 6 years | |
|
Bondtech gears not catching In forum Hardware, firmware and software help |
před 6 years | |
|
Thanks! I'll try this In forum Hardware, firmware and software help |
před 6 years | |
|
Vous êtes-vous assuré d'avoir téléchargé slic3r pour mac? In forum Hardware, firmware and software help |
před 6 years | |
|
Uneven layering with prints In forum Hardware, firmware and software help |
před 6 years | |
|
Nevermind, just had the SD card locked In forum Hardware, firmware and software help |
před 6 years | |
|
Can't Load files onto SD card In forum Hardware, firmware and software help |
před 6 years |
Stránka 2 / 2
Předchozí