Avisos
Vaciar todo
TH Sturgill
Grupo: Registrado
Registrado: 2016/10/03
Active Member
1
|
Slic3r PE 1.38.4 En el foro Software (Archive) |
hace 7 years | |
|
one first load it will print the wipe line and then nothing
... En el foro Assembly and first prints troubleshooting |
hace 8 years | |
|
My PTFE tube is tapered on the top flat with no taper on the... En el foro Assembly and first prints troubleshooting |
hace 8 years | |
|
Three comments:
1) If possible, slicer costs should show aft... En el foro Software (Archive) |
hace 8 years | |
|
Would you please try the following Linux wx-gtk2 libs?
Missi... En el foro Software (Archive) |
hace 8 years | |
|
The libwx_gtk2u* files are not available on Fedora in that v... En el foro Software (Archive) |
hace 8 years | |
|
Actually we provide a Slic3r build for 64bit linux, built on... En el foro Software (Archive) |
hace 8 years | |
|
Since there are not Linux builds from Prusa, I'm using the S... En el foro Software (Archive) |
hace 8 years |