Prusa3D Forum

Notifications

Clear all

Tgunn

Groupe: Enregistré

A(ont) rejoint: 2024/03/02

Active Member

	Yeah if I adjust the live z it's pretty consistent. My prob... Dans le forum Hardware, firmware and software help	il y a 6 months
	Out of curiosity what do you use to clean the nozzle? I ha... Dans le forum Hardware, firmware and software help	il y a 6 months
	I have reached out to Prusa support but after 3 weeks of bac... Dans le forum Hardware, firmware and software help	il y a 6 months
	I think the problem is that there is filament leftover from ... Dans le forum Hardware, firmware and software help	il y a 7 months
	I'm also unable to get reliable first layers on the regular ... Dans le forum Hardware, firmware and software help	il y a 7 months
	Agree, I think this is the same issue. Setting the live Z t... Dans le forum Hardware, firmware and software help	il y a 7 months
	0.6mm HF nozzle first layer lines are too fine on textured s... Dans le forum Hardware, firmware and software help	il y a 7 months
	Resurrecting this thread; AWESOME tip. I tore apart my work... Dans le forum Hardware, firmware and software help	il y a 2 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

9 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé