Activité
 
Notifications
Clear all
Texy
Texy
Groupe: Enregistré
A(ont) rejoint: 2018/09/25
Reputable Member
5
No issues here - prints fine : ...

Dans le forum General discussion, announcements and releases

il y a 6 years
The download had multiple models. Which one are you printing...

Dans le forum General discussion, announcements and releases

il y a 6 years
Just to be clear, its the bed temp raising that had the desi...

Dans le forum General discussion, announcements and releases

il y a 6 years
When you say the printer wont print anything, what exactly d...

Dans le forum General discussion, announcements and releases

il y a 6 years
Just to be clear, its the bed temp raising that had the desi...

Dans le forum General discussion, announcements and releases

il y a 6 years
I then wiped the bed with 99% IPA, raised the bed from 60 to...

Dans le forum General discussion, announcements and releases

il y a 6 years
My input so far has been partly selfish as I have the same p...

Dans le forum General discussion, announcements and releases

il y a 6 years
Those temps seem high for PLA, or are they the norm for that...

Dans le forum General discussion, announcements and releases

il y a 6 years
There is no 'link above' to the dragon STL.....or have I mis...

Dans le forum General discussion, announcements and releases

il y a 6 years
To me that doesn’t look too bad. Maybe slightly too squished...

Dans le forum General discussion, announcements and releases

il y a 6 years
What's your first layer like. Try the attached stl, then pos...

Dans le forum General discussion, announcements and releases

il y a 6 years
Meshroom ? Youtube vids are available, or just google. Not t...

Dans le forum General discussion, announcements and releases

il y a 6 years
One thing worthing thinking about, is that you've reported t...

Dans le forum General discussion, announcements and releases

il y a 6 years
I started having PLA prints popping off and I have cleaned t...

Dans le forum Hardware, firmware and software help

il y a 6 years
Be sure to report back on how you get on Joan. Texy.

Dans le forum General discussion, announcements and releases

il y a 6 years
Wouldn't it be great if Prusa could supply a sheet with smoo...

Dans le forum General discussion, announcements and releases

il y a 6 years
A little bit of ignorance on my part but...Where does the pi...

Dans le forum General discussion, announcements and releases

il y a 6 years
A firmware update for a front panel option to disable the MM...

Dans le forum General discussion, announcements and releases

il y a 6 years
Benn there - done that 😀 Texy

Dans le forum General discussion, announcements and releases

il y a 6 years
Have you printed a standard 20 mm XYZ calibration cube? Wha...

Dans le forum General discussion, announcements and releases

il y a 6 years
Page 18 / 20
Partager :