Prusa3D Forum

Notifications

Clear all

Teemu Anttila

Groupe: Enregistré

A(ont) rejoint: 2021/03/24

Eminent Member

	@3delight Yes all things are just you said. and then:1. Yes... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@bobstro Im printing only PETG... so thats pretty weird this... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@bobstro I have tried retruction 0,4-0,8 temp 240-260, extru... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@3delight Yes its running ok and all clean. Dans le forum How do I print this? (Printing help)	il y a 4 years
	@clarmrrsn It was locked with black collet didn't move at al... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@clarmrrsn I opened hotend and all looks to be ok.Here is th... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@swiss_cheese Here is the picture of melted filament diamete... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@swiss_cheese But it have happened now with 5 different prin... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@swiss_cheese Checked also that many times. Now I used 0,4mm... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@peter-m Its checked, all fine in that side. Dans le forum How do I print this? (Printing help)	il y a 4 years
	@swiss_cheese Same problem again. Going up with heat didn't ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@swiss_cheese Hi. Here are the files that last have failed. ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	This machine is pain in the ass. The problem is not solved I... Dans le forum How do I print this? (Printing help)	il y a 4 years
	I get the printing done. I use temp 240/85 and extra table f... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@diem Hi. I print the tube that was 10cm high and it takes 1... Dans le forum How do I print this? (Printing help)	il y a 4 years
	This machine is totally pain in the ass! I have now cleaned ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Printing always stops about same time, between 6 and 7 hours... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@clarmrrsn I run PETG Prusament in 240/250 temp. I think ext... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Printing problem Dans le forum How do I print this? (Printing help)	il y a 4 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

24 En-ligne

68.1 K Membres

Le dernier des messages: Extruder stops mid-print Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé