|
Thank you everyone. This really healps to understand support... En el foro PrusaSlicer |
hace 3 years |
|
Attached is the .3mf file with the settings how I printed it... En el foro PrusaSlicer |
hace 3 years |
|
Edit-timer ran out.
When using Paint-on Support, it also ... En el foro PrusaSlicer |
hace 3 years |
|
My apologies, really should have included the image in the f... En el foro PrusaSlicer |
hace 3 years |
|
"Support blocker" doesn't affect supports from "Support enfo... En el foro PrusaSlicer |
hace 3 years |
|
Never figured out, what the issue was, but it's working fine... En el foro General software discussion |
hace 3 years |
|
Yes, I didn't realize, that option also had to be enabled in... En el foro PrusaSlicer |
hace 3 years |
|
@Neophyl Without "use volumetric E", it prints fine with an ... En el foro PrusaSlicer |
hace 3 years |
|
Not sure, if you've the exact same problem, but my Mini used... En el foro Hardware, firmware and software help |
hace 3 years |
|
Sorry, meant extrusion multiplier, not flowrate. On the Cr-1... En el foro PrusaSlicer |
hace 3 years |
|
PrusaSlicer requires really low Flowrate to not overextrude? En el foro PrusaSlicer |
hace 3 years |
|
Bondtech CHT profile? En el foro Hardware, firmware and software help |
hace 3 years |
|
Printing TPU on a stock mini, the extruder has zero problems... En el foro How do I print this? (Printing help) |
hace 3 years |
|
Looks great 😀 En el foro PrusaSlicer |
hace 3 years |
|
Perfect, those placeholder changes worked. Now it's slicing ... En el foro PrusaSlicer |
hace 3 years |
|
"Invalid data" when slicing? G-code is messed up... En el foro PrusaSlicer |
hace 3 years |
|
Found a workable solution: There's an "outer brim only" opti... En el foro PrusaSlicer |
hace 3 years |
|
Build improvement idea for the Mini En el foro Hardware, firmware and software help |
hace 3 years |
|
When trying the method with 0 perimeters or infill, the Slic... En el foro PrusaSlicer |
hace 3 years |
|
Add Brim to specific sections only? En el foro PrusaSlicer |
hace 3 years |
