|
We finally got it out. The filament still stuck made it a b... In forum Hardware, firmware and software help |
4 years ago |
|
@steve_g The filament won't budge. Even before I snipped it... In forum Hardware, firmware and software help |
4 years ago |
|
Filament still inside Hotend but thermistor broken In forum Hardware, firmware and software help |
4 years ago |
|
@neophyl So I've been printing a few little things here and ... In forum Hardware, firmware and software help |
4 years ago |
|
I haven't changed much. Only on rectilinear infill does the... In forum Hardware, firmware and software help |
4 years ago |
|
@ron So far there hasn't been any more dropping but I will l... In forum Hardware, firmware and software help |
4 years ago |
|
@vintagepc Then why did Zodiac provide it? In forum Hardware, firmware and software help |
4 years ago |
|
So while I still wait for the nylon cleaning filament, I fur... In forum Hardware, firmware and software help |
4 years ago |
|
Hi @bobstro, I've removed the cooling duct, raised the tem... In forum Hardware, firmware and software help |
4 years ago |
|
@bobstro I will try to get a wire brush and do the investiga... In forum Hardware, firmware and software help |
4 years ago |
|
Burning Extrusion In forum Hardware, firmware and software help |
4 years ago |
|
I figured it out. I ended up removing the nozzle, then rein... In forum Hardware, firmware and software help |
4 years ago |
|
Edit: I will mention that I'm not sure why I turned off Only... In forum Hardware, firmware and software help |
4 years ago |
|
Weird sploots and burnt plastic? In forum Hardware, firmware and software help |
4 years ago |
|
I must say, I regret not posting my issues sooner. While I ... In forum How do I print this? (Printing help) |
5 years ago |
|
Thanks for the answers. I'll look into reducing the Z-level... In forum How do I print this? (Printing help) |
5 years ago |
|
I have not washed it with dish soap. I had wiped it with a ... In forum How do I print this? (Printing help) |
5 years ago |
|
Prints lifting from textured bed In forum How do I print this? (Printing help) |
5 years ago |
