Prusa3D Forum

Notifications

Clear all

Talltim58

Groupe: Enregistré

A(ont) rejoint: 2025/01/07

Active Member

	CORE ONE Crashing when opening the door Dans le forum General discussion, announcements and releases	il y a 2 months
	I bought the MK4 used it for several months till the S upgra... Dans le forum General discussion, announcements and releases	il y a 3 months
	I had to take off my iPhone cover clean the microphone cover... Dans le forum Hardware, firmware and software help	il y a 3 months
	Ordered my MK4S core one upgrade kit January 26 2025 with ca... Dans le forum General discussion, announcements and releases	il y a 7 months
	I ordered my Prusa Core One kit the instant it became availa... Dans le forum General discussion, announcements and releases	il y a 8 months
	My overcurrent error has finally gone away after downloading... Dans le forum Hardware, firmware and software help	il y a 9 months
	I have a MK4 with a MK4S upgrade kit then added a preassembl... Dans le forum Hardware, firmware and software help	il y a 9 months
	I had and found the same problem don't forget to check your ... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	I'm very new to 3D printing and I had the same issue so I st... Dans le forum Hardware, firmware and software help	il y a 11 months

Statistiques du forum

595 Forums

69.3 K Sujets

485.3 K Messages

12 En-ligne

78.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé