Prusa3D Forum

Notifications

Clear all

T_om

Groupe: Enregistré

A(ont) rejoint: 2023/02/08

Eminent Member

	In 3d printing model aircraft using LW PLA, which foams up a... Dans le forum PrusaSlicer	il y a 1 year
	I would expect it to go from one island to another just as i... Dans le forum PrusaSlicer	il y a 1 year
	Avoid Crossing Perimeters Not being applied to support Dans le forum PrusaSlicer	il y a 1 year
	By the way, not all Marlin firmware supports the M600 GCODE ... Dans le forum PrusaSlicer	il y a 1 year
	I'll zip them both and try again. Tom a3d39880-3mf... Dans le forum PrusaSlicer	il y a 1 year
	Organic Paint On Supports Randomly Cease Working. Part Two Dans le forum PrusaSlicer	il y a 1 year
	Organic Paint On Supports Randomly Cease Working Dans le forum PrusaSlicer	il y a 1 year
	Of course parts can me shifted. This thread is about instan... Dans le forum PrusaSlicer	il y a 1 year
	Nope. A red circle/bar appears when trying to pull one inst... Dans le forum PrusaSlicer	il y a 1 year
	Yep. This still pretty much sucks. At least let the added ... Dans le forum PrusaSlicer	il y a 1 year
	Actually the request is simple, just don't turn off bridging... Dans le forum PrusaSlicer	il y a 2 years
	Here is one example. FF-3-4-5-Stacked-Example.zip Dans le forum PrusaSlicer	il y a 2 years
	Bridging turned off and Bridge Speed not available when part... Dans le forum PrusaSlicer	il y a 2 years
	I will have to re-create the project if I can recall the exa... Dans le forum PrusaSlicer	il y a 2 years
	Yeah, I thought the same thing. But it happened to me too. ... Dans le forum PrusaSlicer	il y a 2 years
	OK. It would sure be nice if there were a way to "tell" the... Dans le forum PrusaSlicer	il y a 2 years
	Force organic tree supports on vertical surface. Dans le forum PrusaSlicer	il y a 2 years
	This is a pretty big drawback. And it doesn't appear to be ... Dans le forum PrusaSlicer	il y a 2 years
	Feature restrictions on modified layers, any workarounds??? Dans le forum PrusaSlicer	il y a 2 years
	Over 260 views and NO ONE knows how to just turn off bridgin... Dans le forum PrusaSlicer	il y a 2 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.6 K Sujets

446.4 K Messages

22 En-ligne

69.1 K Membres

Le dernier des messages: Xl extruder stops Notre nouveau membre: twh344 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé